Drilling the front upper wishbone brackets

After a lot of grinding the brackets down to make them fit, Here we see Joey drilling a hole through the Top Wishbone Angle and into the chassis, The front wishbone fits directly into the Chassis Box section and you place the supplied bracket into place up against the forward face of the rear wishbone bearing then drill upwards throught the bracket.

Here you see the bracket bolted in place, The Black pen mark shows where we intend to trim the excess material off.

Ours needs 13mm spacing at the rear end of the upper wishbone, Quite a gap!

Joey looks pleased his LH wishbones are all assembled. Shame we have to remove them again because we want the Wishbones Plastic coated because the paint is Crap.

Back